(solved) ULink2 & EzSBC2 in Keil MDK = "Flash timeout"

(solved) ULink2 & EzSBC2 in Keil MDK = "Flash timeout"

Postby jonneva » Wed Jun 24, 2015 4:49 pm

I've connected my ULink2 to the EzSBC2 board as follows:

Image

I see the device correctly identified in the JTAG/SW window (SWDIO 0x2BA01477)

But, no matter how I try I always get a "flash timeout" when trying to access the flash. I even wrote my own flash programming file just in case. No go.

It is as if reset fails to fire.

Has anyone tried Ulink2 with the EzSBC2 ? What am I missing ?

I also connected to the J2 SW header. Same result.
Last edited by jonneva on Thu Jun 25, 2015 1:03 pm, edited 1 time in total.
jonneva
 
Posts: 8
Joined: Fri Jun 12, 2015 1:33 pm

Re: ULink2 & EzSBC2 in Keil MDK = "Flash timeout"

Postby jonneva » Thu Jun 25, 2015 1:03 pm

UPDATE: works perfectly after ULINK2 firmware update
jonneva
 
Posts: 8
Joined: Fri Jun 12, 2015 1:33 pm


Return to EzSBC2

Who is online

Users browsing this forum: No registered users and 1 guest

cron