Shield layout question

[rmccown]

Hey folks. First time poster here.

I'm designing a 'shield' in Eagle for the ESP32-01 to plug into, to mimic one I designed for an Uno based project, and was wondering what to use for pin layout for the board socket? I can measure and get it right, but I was wondering if there was an object in Eagle that would be usable?

Thanks
-=Bob

[Daniel]

I don't use Eagle. I have attached a simplified drawing that shows the board dimensions, hole and pin positions.

It would be great if you were to share the footprint with others.

Daniel

[rick505]

Hey folks. First time poster here.

I'm designing a 'shield' in Eagle for the ESP32-01 to plug into, to mimic one I designed for an Uno based project, and was wondering what to use for pin layout for the board socket? I can measure and get it right, but I was wondering if there was an object in Eagle that would be usable?

Thanks
-=Bob

Curious if you completed your design and if so, are you making it available for others to see/use? Not intending anything for commercial use but I have a couple projects I'm "Playing" with using the ESP32-01 module.

[rmccown]

I'm just getting back into this, so I should have something soon-ish

[rmccown]

OK, this looks like a good first cut. I can lay it out in Eagle, at least.

https://www.dropbox.com/s/3hwl4b10tejlm ... c.lbr?dl=0

[rmccown]

Following up on this. I have a second run of prototype boards coming from PCBway. The footprint I had used the wrong drill sizes, so the socket for the ESP01 was tight. This one should be fine, I've updated the Eagle library.