Shield layout question

Schematics, Example Code and Q&A
rmccown
Posts: 5
Joined: Mon Mar 18, 2019 7:11 pm

Shield layout question

Unread post by rmccown »

Hey folks. First time poster here.

I'm designing a 'shield' in Eagle for the ESP32-01 to plug into, to mimic one I designed for an Uno based project, and was wondering what to use for pin layout for the board socket? I can measure and get it right, but I was wondering if there was an object in Eagle that would be usable?

Thanks
-=Bob
Daniel
Posts: 133
Joined: Tue Nov 13, 2012 2:10 pm

Re: Shield layout question

Unread post by Daniel »

I don't use Eagle. I have attached a simplified drawing that shows the board dimensions, hole and pin positions.

It would be great if you were to share the footprint with others.

Daniel
Attachments
Mechanical drawing
Mechanical drawing
rick505
Posts: 3
Joined: Mon Aug 26, 2019 11:55 am

Re: Shield layout question

Unread post by rick505 »

rmccown wrote:Hey folks. First time poster here.

I'm designing a 'shield' in Eagle for the ESP32-01 to plug into, to mimic one I designed for an Uno based project, and was wondering what to use for pin layout for the board socket? I can measure and get it right, but I was wondering if there was an object in Eagle that would be usable?

Thanks
-=Bob
Curious if you completed your design and if so, are you making it available for others to see/use? Not intending anything for commercial use but I have a couple projects I'm "Playing" with using the ESP32-01 module.
rmccown
Posts: 5
Joined: Mon Mar 18, 2019 7:11 pm

Re: Shield layout question

Unread post by rmccown »

I'm just getting back into this, so I should have something soon-ish
rmccown
Posts: 5
Joined: Mon Mar 18, 2019 7:11 pm

Re: Shield layout question

Unread post by rmccown »

OK, this looks like a good first cut. I can lay it out in Eagle, at least.

https://www.dropbox.com/s/3hwl4b10tejlm ... c.lbr?dl=0
rmccown
Posts: 5
Joined: Mon Mar 18, 2019 7:11 pm

Re: Shield layout question

Unread post by rmccown »

Following up on this. I have a second run of prototype boards coming from PCBway. The footprint I had used the wrong drill sizes, so the socket for the ESP01 was tight. This one should be fine, I've updated the Eagle library.
Post Reply