Page 1 of 1

Shield layout question

Posted: Tue Mar 19, 2019 12:50 pm
by rmccown
Hey folks. First time poster here.

I'm designing a 'shield' in Eagle for the ESP32-01 to plug into, to mimic one I designed for an Uno based project, and was wondering what to use for pin layout for the board socket? I can measure and get it right, but I was wondering if there was an object in Eagle that would be usable?

Thanks
-=Bob

Re: Shield layout question

Posted: Thu Mar 28, 2019 9:14 am
by Daniel
I don't use Eagle. I have attached a simplified drawing that shows the board dimensions, hole and pin positions.

It would be great if you were to share the footprint with others.

Daniel

Re: Shield layout question

Posted: Tue Aug 27, 2019 8:57 am
by rick505
rmccown wrote:Hey folks. First time poster here.

I'm designing a 'shield' in Eagle for the ESP32-01 to plug into, to mimic one I designed for an Uno based project, and was wondering what to use for pin layout for the board socket? I can measure and get it right, but I was wondering if there was an object in Eagle that would be usable?

Thanks
-=Bob
Curious if you completed your design and if so, are you making it available for others to see/use? Not intending anything for commercial use but I have a couple projects I'm "Playing" with using the ESP32-01 module.

Re: Shield layout question

Posted: Sat Feb 08, 2020 11:12 am
by rmccown
I'm just getting back into this, so I should have something soon-ish

Re: Shield layout question

Posted: Sat Feb 08, 2020 2:01 pm
by rmccown
OK, this looks like a good first cut. I can lay it out in Eagle, at least.

https://www.dropbox.com/s/3hwl4b10tejlm ... c.lbr?dl=0

Re: Shield layout question

Posted: Tue Apr 06, 2021 4:03 pm
by rmccown
Following up on this. I have a second run of prototype boards coming from PCBway. The footprint I had used the wrong drill sizes, so the socket for the ESP01 was tight. This one should be fine, I've updated the Eagle library.