Page 1 of 1

easyeda pcb design

Posted: Tue Nov 19, 2019 4:01 pm
by angus_grant
Hi,

I am just wanting to confirm that measurements are in thousands of an inch.

And to save me some work, would you have a template of the ESP32_ANT-01 board I could import straight into easyeda? :-D

I am looking at building a support board with plugs for temp probes, lcd's etc.

Thanks,
Angus.

Re: easyeda pcb design

Posted: Thu May 14, 2020 11:00 am
by Daniel
I don't really plan on making boards with additional peripherals on board. I offer a customization service where I provide a custom design based on the boards with whatever circuitry you may need. It is inexpensive and worth it if you need more than ten boards of the new design. By the time you buy a hundred boards the cost is only a couple of dollars extra per board to cover the setup and stencil purchases.

Measurements are in thousands of an inch.