ESP32_Ant-1 newby questions

ESP32_Ant-1 newby questions

Postby drmacro » Thu Sep 19, 2019 10:30 am

Just got a couple Ant-1 boards, so getting my feet wet.

Is the schematic on the ESP32-01 Breakout download page the same as the _Ant-1 board? There is nothing on the download page of the Ant-01. (At least as of a couple days ago...)

Is it safe to run the board with a Vin connected to 5V and the USB plugged in at the same time? I see the diode (D1), but can I program with both connected? Can I use Serial.print/Serial.read with both connected?
(yeah, being lazy, I know I could just try it... :oops: )

Also, my prototype (with a Adafruit board) is using GPIO 16 as an input. Can I get away with leaving the LED (on the Ant-1) or should I just save myself the headache and use another pin...? (I know, again with the lazy... :oops: It's really just a wire change on my proto-board and a change one line of code.)

Regards,
Mac
drmacro
 
Posts: 2
Joined: Mon Oct 01, 2018 9:09 am

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron